American Flag Rear Window Overlays V2 (Perforated) - 2024+ Land Cruise

American Flag Rear Window Overlays V2 (Perforated) - 2024+ Land Cruiser

$57.99 $60.00

Model White Carbonized Gray Thin Red Line Thin Blue Line Thin Green Line

Follows proper flag etiquette (star field leads)
Made in the USA
Perforated material allows you to still see through the window
Install video below

2024+ Toyota Land Cruiser Rear Perforated American Flag Overlay Kit

These flags look great in the rear windows of the Toyota Land Cruiser. It's a theme tons of off-roaders have embraced as we set off across the country, enjoying, roads, ruts, trails, beaches, and more.

Fully printed at our Fort Myers office.

NOTE: This comes as a left and right pair. There is a border around the edge to make installation easier and prevent interference of rubber gaskets. This material installs just like our solid printed window vinyls, however it stretches a little bit more easily. Be careful, install in the shade in 70 degree or warmer weather. If you stretch it, you may need to pull it back up or trim. Also DO NOT use a squeegee to install. Proper care of the surface is required. Do not use anything rough to install or care for the material.

Install Notes

Do a wet install in 70 degree or above weather. Make sure you are not in direct sunlight. You will not need a squeegee for this install as you will use your fingers to press down on the vinyl.

Quick Install Video

Customizable

Please contact us if you need additional colors.

Use our contact form to get in touch with us.

Long Install Video

Clean the application area to prepare it for installation. Use glass cleaner to prepare the area.

NOTES: We recommend that the installation area be free of wax and not under direct sunlight.

Microfiber
Glass cleaner
Soapy Water (we recommend our StickerFab Installation Fluid)
Heat Gun or Hair Dryer (optional)

Wet installs require one drop of dish or hand soap in a cup of water. Apply to the vinyl so that the first attempt doesn't make the vinyl permanently stick to the surface. Then you can slide it around and push out the extra water once it is in place with your squeegee.

Try doing the install in the shade so it doesn't heat up the vinyl rapidly. Try to even out the gaps at the ends. Because of the rubber trim we wanted to leave a little room for error in alignment.

Watch our video for more details. We purposely did a long installation and did not skip any parts. You may fast forward and rewind at your own leisure.